Users Guide
Table Of Contents
- Dell Lifecycle Controller GUI v2.50.50.50 User's Guide
- Introduction
- Using Lifecycle Controller
- Operating system deployment
- Monitor
- Hardware inventory view and export
- About view and export current inventory
- About view and export factory-shipped inventory
- Viewing hardware inventory — current or factory shipped
- Exporting hardware inventory — current or factory shipped
- Viewing or exporting hardware inventory after part replacement
- Viewing or exporting current inventory after resetting Lifecycle Controller
- Lifecycle Controller log
- Firmware update
- Configure
- System control panel access options
- Configuring iDRAC
- Configuring system time and date
- Configuring vFlash SD card
- Configuring RAID
- Configuring RAID using software RAID
- Creating a secure virtual disk on a RAID controller
- Key encryption
- Local key encryption mode
- Breaking mirrored drives
- System setup — Advanced Hardware Configuration
- Collect system inventory on restart
- Configuring local FTP server
- Configuring a local USB drive
- Configuring NFS and CIFS servers
- Conditions while configuring HTTP server
- Maintain
- Platform restore
- Backup server profile
- Export server profile
- Import server profile
- Import server license
- Part replacement configuration
- Repurpose or retire system
- Hardware diagnostics
- SupportAssist Collection
- Easy-to-use system component names
- Using the system setup and boot manager
- Troubleshooting and frequently asked questions
Table 7. Post reboot scenarios
Scenario User Action and Impact
NOTE: If you press <F10> during the installation process or a
restart, the drivers provided by the operating system deployment
wizard are removed.
During the 18-hour period when drivers are extracted
to a temporary location after the operating system is
installed, you cannot update the component firmware
using a DUP. If you attempt a DUP through the
operating system during this time period, the DUP
displays a message that another session is active.
Lifecycle Controller does not allow DUP after the operating system
installation. However, if you disconnect the power supply to the
managed system, the OEMDRV directory is erased.
Related tasks
Installing an operating system on page 20
Using the optional RAID configuration on page 21
24 Operating system deployment