Reference Guide

Table Of Contents

● System events

● Storage devices

● Network devices

● Configuration

● Audit

● Updates

You can view and filter logs based on the category and severity level. You can also export and add a work note to a log event.

If you initiate configuration jobs using RACADM CLI or iDRAC web interface, the Lifecycle log captures the information about

the user, interface used, and the IP address of the system from which you initiate the job.

Supported RACADM Subcommands

The following table provides the list of RACADM subcommands and their corresponding interface support. For more information

about the RACADM subcommands including syntax and valid entries, see RACADM Subcommand Details on page 17.

Table 2. Supported RACADM Subcommands

Subcommand iDRAC on Blade Servers

Telnet/SSH/

Serial

Local RACADM Remote

RACADM

autoupdatescheduler on page 19 Yes Yes Yes

arp on page 19 Yes Yes Yes

clearasrscreen on page 22 Yes Yes Yes

clearpending on page 23 Yes Yes Yes

closessn on page 23 Yes Yes Yes

clrsel on page 24 Yes Yes Yes

config on page 24 Yes Yes Yes

coredump on page 25 Yes Yes Yes

coredumpdelete on page 26 Yes Yes Yes

diagnostics on page 26 Yes Yes Yes

eventfilters on page 27 Yes Yes Yes

fcstatistics on page 29 Yes Yes Yes

frontpanelerror on page 29 Yes Yes Yes

fwupdate on page 29 Yes Yes Yes

get on page 31 Yes Yes Yes

getconfig on page 33 Yes Yes Yes

gethostnetworkinterfaces on page 36 Yes Yes Yes

getled on page 36 Yes Yes Yes

getniccfg on page 37 Yes Yes Yes

getraclog on page 38 Yes Yes Yes

getractime on page 39 Yes Yes Yes

getsel on page 39 Yes Yes Yes

getsensorinfo on page 40 Yes Yes Yes

getssninfo on page 44 Yes Yes Yes

getsvctag on page 45 Yes Yes Yes

Introduction 13