Users Guide

Object Description Usage Example
FanSpeedHighOffsetVa
l, and
FanSpeedMediumOffset
Val objects (dened earlier)
are the values at which the
osets are applied.
MFSMaximumLimit
Read Maximum limit for MFS
Values from 1 — 100 To display the highest value that
can be set using
MinimumFanSpeed option:
racadm get
system.thermalsettings.
MFSMaximumLimit
MFSMinimumLimit
Read Minimum limit for MFS
Values from 0 to
MFSMaximumLimit
Default is 255 (means None)
To display the lowest value that
can be set using
MinimumFanSpeed option.
racadm get
system.thermalsettings.
MFSMinimumLimit
MinimumFanSpeed
• Allows conguring the
Minimum Fan speed that is
required for the system to
operate.
• It denes the baseline (oor)
value for fan speed and
system allows fans to go
lower than this dened fan
speed value.
• This value is %PWM value
for fan speed.
Values from
MFSMinimumLimit to
MFSMaximumLimit
When get command reports 255,
it means user congured oset is
not applied.
To make sure that the system
minimum speed does not
decrease lower than 45% PWM
(45 must be a value between
MFSMinimumLimit to
MFSMaximumLimit):
racadm set
system.thermalsettings.
MinimumFanSpeed 45
ThermalProfile
• Allows you to specify the
Thermal Base Algorithm.
• Allows you to set the system
prole as required for thermal
behavior associated to the
prole.
Values:
• 0 — Auto
• 1 — Maximum performance
• 2 — Minimum Power
To view the existing thermal
prole setting:
racadm get
system.thermalsettings.
ThermalProfile
To set the thermal prole to
Maximum Performance:
racadm set
system.thermalsettings.
ThermalProfile 1
ThirdPartyPCIFanRespons
e
• Thermal overrides for third-
party PCI cards.
• Allows you to disable or
enable the default system
fan response for detected
third-party PCI cards.
• You can conrm the
presence of third-party PCI
card by viewing the message
ID PCI3018 in the Lifecycle
Controller log.
Values:
• 1 — Enabled
• 0 — Disabled
NOTE: The default value
is 1.
To disable any default fan speed
response set for a detected
third-party PCI card:
racadm set
system.thermalsettings.
ThirdPartyPCIFanRespons
e 0
Setting up managed system and management station 59