Users Guide

To congure the IPv6 settings:

1 Select Enabled option under Enable IPv6.

2 For the DHCPv6 server to automatically assign the IP address, gateway, and subnet mask to iDRAC, select Enabled option under

Enable Auto-conguration.

NOTE: You can congure both static IP and DHCP IP at the same

time.

In the Static IP Address 1 box, enter the static IPv6 address.

4 In the Static Prex Length box, enter a value between 0 and 128.

5 In the Static Gateway box, enter the gateway address.

NOTE: If you congure static IP, the current IP address 1 displays static IP and the IP address 2 displays dynamic IP. If

you clear the static IP settings, the current IP address 1 displays dynamic IP.

6 If you are using DHCP, enable DHCPv6 to obtain DNS Server addresses to obtain Primary and Secondary DNS server addresses

from DHCPv6 server. You can congure the following if required:

• In the Static Preferred DNS Server box, enter the static DNS server IPv6 address.

• In the Static Alternate DNS Server box, enter the static alternate DNS server.

IPMI settings

To enable the IPMI Settings:

1 Under Enable IPMI Over LAN, select Enabled.

2 Under Channel Privilege Limit, select Administrator, Operator, or User.

3 In the Encryption Key box, enter the encryption key in the format 0 to 40 hexadecimal characters (without any blanks characters.)

The default value is all zeros.

VLAN settings

You can congure iDRAC into the VLAN infrastructure. To congure VLAN settings, perform the following steps:

NOTE

: On blade servers that are set as Chassis (Dedicated), the VLAN settings are read-only and can be changed only using

CMC. If the server is set in shared mode, you can congure VLAN settings in shared mode in iDRAC.

1 Under Enable VLAN ID, select Enabled.

2 In the VLAN ID box, enter a valid number from 1 to 4094.

3 In the Priority box, enter a number from 0 to 7 to set the priority of the VLAN ID.

NOTE

: After enabling VLAN, the iDRAC IP is not accessible for some time.

Setting up iDRAC IP using CMC web interface

To set up the iDRAC IP address using CMC Web interface:

NOTE

: You must have Chassis Conguration Administrator privilege to set up iDRAC network settings from

CMC.

1 Log in to CMC Web interface.

2 Go to Server Overview > Setup > iDRAC.

The Deploy iDRAC page is displayed.

3 Under iDRAC Network Settings, select Enable LAN and other network parameters as per requirements. For more information, see

CMC online help.

Setting up managed system and management station