Users Guide

Setting up iDRAC IP address

You must congure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You

can set up the IP address using one of the following interfaces:

• iDRAC Settings utility

• Lifecycle Controller (see Lifecycle Controller User’s Guide)

• Dell Deployment Toolkit (see Dell Deployment Toolkit User’s Guide)

• Chassis or Server LCD panel (see the system’s Hardware Owner’s Manual)

NOTE: In case of blade servers, you can congure the network setting using the Chassis LCD panel only during initial

conguration of CMC. After the chassis is deployed, you cannot recongure iDRAC using the Chassis LCD panel.

• CMC Web interface (see Dell Chassis Management Controller Firmware User’s Guide)

In case of rack and tower servers, you can set up the IP address or use the default iDRAC IP address 192.168.0.120 to congure initial

network settings, including setting up DHCP or the static IP for iDRAC.

In case of blade servers, the iDRAC network interface is disabled by default.

After you congure iDRAC IP address:

• Ensure that you change the default user name and password after setting up the iDRAC IP address.

• Access iDRAC through any of the following interfaces:

• iDRAC Web interface using a supported browser (Internet Explorer, Firefox, Chrome, or Safari)

• Secure Shell (SSH) — Requires a client such as PuTTY on Windows. SSH is available by default in most of the Linux systems and

hence does not require a client.

• Telnet (must be enabled, since it is disabled by default)

• IPMITool (uses IPMI command) or shell prompt (requires Dell customized installer in Windows or Linux, available from Systems

Management Documentation and Tools DVD or dell.com/support)