Users Guide

You can install this feature by using the setup.sh le that is available with the Web pack. This feature is disabled on a default or typical iSM
installation. To get the status of this feature, use the following command:
Enable-iDRACAccessHostRoute get-status
To install, enable, and congure this feature, use the following command:
./Enable-iDRACAccessHostRoute <Enable-Flag> [ <source-port> <source-IP-range/source-ip-range-
mask>]
<Enable-
Flag>=0
Disable
<source-port> and <source-IP-range/source-ip-range-mask> are not
required.
<Enable-
Flag>=1
Enable
<source-port> is required and <source-ip-range-mask> is optional.
<source-IP-
range>
IP range in <IP-Address/subnet-mask> format. Example: 10.95.146.98/24
Coexistence of OpenManage Server Administrator and iDRAC
Service Module
In a system, both OpenManage Server Administrator and the iDRAC Service Module can co-exist and continue to function correctly and
independently.
If you have enabled the monitoring features during the iDRAC Service Module installation, then after the installation is complete if the
iDRAC Service Module detects the presence of OpenManage Server Administrator, it disables the set of monitoring features that overlap. If
OpenManage Server Administrator is running, the iDRAC Service Module disables the overlapping monitoring features after logging to the
OS and iDRAC.
When you re-enable these monitoring features through the iDRAC interfaces later, the same checks are performed and the features are
enabled depending on whether OpenManage Server Administrator is running or not.
Using iDRAC Service Module from iDRAC web
interface
To use the iDRAC Service Module from the iDRAC web interface:
1 Go to Overview > Server > Service Module.
The iDRAC Service Module Setup page is displayed.
2 You can view the following:
• Installed iDRAC Service Module version on the host operating system
• Connection status of the iDRAC Service Module with iDRAC.
3 To perform out-of-band monitoring functions, select one or more of the following options:
• OS Information — View the operating system information.
• Replicate Lifecycle Log in OS Log — Include Lifecycle Controller logs to operating system logs. This option is disabled if
OpenManage Server Administrator is installed on the system.
• WMI Information — Include WMI information.
• Auto System Recovery Action — Perform auto recovery operations on the system after a specied time (in seconds):
• Reboot
288
Using iDRAC Service Module