Users Guide

Creating a partition using an image le using web interface
To create a vFlash partition from an image le:
1 In iDRAC Web interface, go to Overview > Server > vFlash > Create From Image.
The Create Partition from Image File page is displayed.
2 Enter the required information and click Apply. For information about the options, see the iDRAC Online Help.
A new partition is created. For CD emulation type, a read-only partition is created. For Floppy or Hard Disk emulation type, a read-write
partition is created. An error message is displayed if:
• The card is write-protected
• The label name matches the label of an existing partition.
• The size of the image le is greater than 4 GB or exceeds the available space on the card.
• The image le does not exist or the image le extension is neither .img nor .iso.
• An initialize operation is already being performed on the card.
Creating a partition from an image le using RACADM
To create a partition from an image le using RACADM:
1 Log in to the system using telnet, SSH, or Serial console.
2 Enter the command
racadm vflashpartition create –i 1 –o drive1 –e HDD –t image –l //myserver/sharedfolder/
foo.iso –u root –p mypassword
By default, the created partition is read-only. This command is case sensitive for the image le name extension. If the le name
extension is in upper case, for example FOO.ISO instead of FOO.iso, then the command returns a syntax error.
NOTE
: This feature is not supported in local RACADM.
NOTE: Creating vFlash partition from an image le located on the CFS or NFS IPv6 enabled network share is not
supported.
Formatting a partition
You can format an existing partition on the vFlash SD card based on the type of le system. The supported le system types are EXT2,
EXT3, FAT16, and FAT32. You can only format partitions of type Hard Disk or Floppy, and not CD. You cannot format read-only partitions.
Before creating a partition from an image le, ensure that:
• You have Access Virtual Media privilege.
• The card is initialized.
• The card is not write-protected.
• An initialize operation is not being performed on the card.
To format vFlash partition:
1 In iDRAC Web interface, go to Overview > Server > vFlash > Format.
The Format Partition page is displayed.
2 Enter the required information and click Apply.
For information about the options, see the iDRAC Online Help.
A warning message indicating that all the data on the partition will be erased is displayed.
Managing vFlash SD card
267