Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManageriDRAC7/8 with Lifecycle Controller Version 2.50.50.50
211212213214215216217218219220
6 Click Apply.
Based on the selected operation mode, the settings are applied.
Related link
Choosing operation mode using web interface
Assigning or unassigning global hot spare using RACADM
Use the storage command and specify the type as global hot spare.
For more information, see the iDRAC RACADM Command Line Reference Guide available at dell.com/idracmanuals.
Related link
Choosing operation mode using RACADM
Converting a physical disk to RAID or non-RAID mode
Converting a physical disk to RAID mode enables the disk for all RAID operations. When a disk is in a non-RAID mode, the disk is exposed to
the operating system unlike uncongured good disks and is used in a direct pass-through mode.
You can convert the physical disk drives to RAID or non-RAID mode by:
• Using iDRAC interfaces such as iDRAC web interface, RACADM, or WS-MAN.
• Pressing Ctrl+R while restarting the server and selecting the required controller.
NOTE
: Converting the mode is not supported on PERC hardware controllers running in HBA mode.
NOTE: Converting to non-RAID mode for PERC 8 controllers is supported only for PERC H310 and H330 controllers.
NOTE: If the physical drives connected to a PERC controller are in non-RAID mode, the size of the disk displayed in the iDRAC
interfaces, such as iDRAC GUI, RACADM, and WS-MAN, may be slightly less than the actual size of the disk. However, you can
use the full capacity of the disk to deploy operating systems.
Converting physical disks to RAID capable or non-RAID mode using the
iDRAC web interface
To convert the physical disks to RAID mode or non-RAID mode, perform the following steps:
1 In the iDRAC web interface, click Overview > Storage > Physical Disks > Setup.
The Setup page is displayed.
2 From the Controller drop-down menu, select a controller.
The physical disks associated with the selected controller are displayed.
3 From the Action — Assign to All drop-down box, select the required option (Convert to RAID or Convert to Non-RAID) for all the
disks, or select the option for specic disks from the Action drop-down menu.
4 From the Apply Operation Mode drop-down menu, select when you want to apply the settings.
5 Click Apply.
The settings are applied based on the option selected in the operation mode.
Converting physical disks to RAID capable or non-RAID mode using
RACADM
Depending on whether you want to convert to RAID or Non-RAID mode, use the following RACADM commands
212
Managing storage devices