Users Guide

4 To congure SNMP destination:

• Set the SNMP trap destination for SNMPv3:

racadm set idrac.SNMP.Alert.<index>.DestAddr <IP address>

• Set SNMPv3 users for trap destinations:

racadm set idrac.SNMP.Alert.<index>.SNMPv3Username <user_name>

• Enable SNMPv3 for a user:

racadm set idrac.users.<index>.SNMPv3Enable Enabled

5 To test the trap, if required:

racadm testtrap -i <index>

For more information, see the iDRAC RACADM Command Line Interface Reference Guide available at dell.com/idracmanuals.

Conguring IP alert destinations using iDRAC settings utility

You can congure alert destinations (IPv4, IPv6, or FQDN) using the iDRAC Settings utility. To do this:

1 In the iDRAC Settings utility, go to Alerts.

The iDRAC Settings Alerts page is displayed.

2 Under Trap Settings, enable the IP address(es) to receive the traps and enter the IPv4, IPv6, or FQDN destination address(es). You

can specify up to eight addresses.

3 Enter the community string name.

For information about the options, see the iDRAC Settings Utility Online Help.

4 Click Back, click Finish, and then click Yes.

The alert destinations are congured.

Conguring email alert settings

You can congure the email address to receive the email alerts. Also, congure the SMTP server address settings.

NOTE

: If your mail server is Microsoft Exchange Server 2007, make sure that iDRAC domain name is congured for the mail

server to receive the email alerts from iDRAC.

NOTE: Email alerts support both IPv4 and IPv6 addresses. The DRAC DNS Domain Name must be specied when using

IPv6.