Users Guide

Conguring iDRAC to send alerts

You can set alerts and actions for certain events that occur on the managed system. An event occurs when the status of a system

component is greater than the pre-dened condition. If an event matches an event lter and you have congured this lter to generate an

alert (e-mail, SNMP trap, IPMI alert, remote system logs, Redsh event, or WS events), then an alert is sent to one or more congured

destinations. If the same event lter is also congured to perform an action (such as reboot, power cycle, or power o the system), the

action is performed. You can set only one action for each event.

To congure iDRAC to send alerts:

1 Enable alerts.

2 Optionally, you can lter the alerts based on category or severity.

3 Congure the e-mail alert, IPMI alert, SNMP trap, remote system log, Redsh event, operating system log, and/or WS-event settings.

4 Enable event alerts and actions such as:

• Send an email alert, IPMI alert, SNMP traps, remote system logs, Redsh event, operating system log, or WS events to congured

destinations.

• Perform a reboot, power o, or power cycle the managed system.

Topics:

• Enabling or disabling alerts

• Filtering alerts

• Setting event alerts

• Setting alert recurrence event

• Setting event actions

• Conguring email alert, SNMP trap, or IPMI trap settings

• Conguring WS Eventing

• Conguring Redsh Eventing

• Monitoring chassis events

• Alerts message IDs