Users Guide

The Hardware Inventory section displays the information for the following components available on the managed system:
• iDRAC
• RAID controller
• Batteries
• CPUs
• DIMMs
• HDDs
• Backplanes
• Network Interface Cards (integrated and embedded)
• Video card
• SD card
• Power Supply Units (PSUs)
• Fans
• Fibre Channel HBAs
• USB
• NVMe PCIe SSD devices
The Firmware Inventory section displays the rmware version for the following components:
• BIOS
• Lifecycle Controller
• iDRAC
• OS driver pack
• 32-bit diagnostics
• System CPLD
• PERC controllers
• Batteries
• Physical disks
• Power supply
• NIC
• Fibre Channel
• Backplane
• Enclosure
• PCIe SSDs
NOTE
: Software inventory displays only the last 4 bytes of the rmware version. For example, if the rmware version is
FLVDL06, the rmware inventory displays DL06.
NOTE: On the Dell PowerEdge FX2/FX2s servers, the naming convention of the CMC version displayed in the iDRAC GUI diers
from the version displayed on the CMC GUI. However, the version remains the same.
When you replace any hardware component or update the
rmware versions, make sure to enable and run the Collect System Inventory
on Reboot (CSIOR) option to collect the system inventory on reboot. After a few minutes, log in to iDRAC, and navigate to the System
Inventory page to view the details. It may take up to 5 minutes for the information to be available depending on the hardware installed on
the server.
NOTE
: CSIOR option is enabled by default.
NOTE: Conguration changes and rmware updates that are made within the operating system may not reect properly in the
inventory until you perform a server restart.
Click Export to export the hardware inventory in an XML format and save it to a location of your choice.
Viewing iDRAC and managed system information
107