Users Guide

Uploading server certicate using web interface

To upload the SSL server certicate:

1 In the iDRAC Web interface, go to Overview > iDRAC Settings > Network > SSL, select Upload Server Certicate and click Next.

The Certicate Upload page is displayed.

2 Under File Path, click Browse and select the certicate on the management station.

3 Click Apply.

The SSL server certicate is uploaded to iDRAC.

4 A pop-up message is displayed asking you to reset iDRAC immediately or at a later time. Click Reset iDRAC or Reset iDRAC Later as

required.

iDRAC resets and the new certicate is applied. The iDRAC is not available for a few minutes during the reset.

NOTE: You must reset iDRAC to apply the new certicate. Until iDRAC is reset, the existing certicate is

active.

Uploading server certicate using RACADM

To upload the SSL server certicate, use the sslcertupload command. For more information, see the RACADM Command Line Reference

Guide for iDRAC available at dell.com/idracmanuals.

If the CSR is generated outside of iDRAC with a private key available, then to upload the certicate to iDRAC:

1 Send the CSR to a well-known root CA. CA signs the CSR and the CSR becomes a valid certicate.

2 Upload the private key using the remote racadm sslkeyupload command.

3 Upload the signed certicate to iDRAC using the remote racadm sslcertupload command.

The new certicate is uploaded iDRAC. A message is displayed asking you to reset iDRAC.

4 Run the racadm racreset command to reset iDRAC.

iDRAC resets and the new certicate is applied. The iDRAC is not available for a few minutes during the reset.

NOTE

: You must reset iDRAC to apply the new certicate. Until iDRAC is reset, the existing certicate is

active.

Viewing server certicate

You can view the SSL server certicate that is currently being used in iDRAC.