Users Guide

140 Adding and Configuring iDRAC6 Users
Enabling an iDRAC6 User With Permissions
To enable a user with specific administrative permissions (role-based
authority), first locate an available user index by performing the steps in
"Before You Begin" on page 137. Next, type the following command lines with
the new user name and password.
NOTE: For a list of valid bit mask values for specific user privileges, see the iDRAC6
and CMC Command Line Reference Guide available on the Dell Support website at
support.dell.com/manuals. The default privilege value is 0, which indicates the user
has no privileges enabled.
racadm config -g cfgUserAdmin -o
cfgUserAdminPrivilege -i <index> <user privilege
bitmask value>