Reference Guide

56 RACADM Subcommand Details
Output
The serveraction subcommand displays an error message if the requested
operation could not be performed, or a success message if the operation
completed successfully.
setniccfg
NOTE: To use the setniccfg command, you must have Configure iDRAC permission.
NOTE: The terms NIC and Ethernet management port may be used
interchangeably.
Synopsis
racadm setniccfg -d
racadm setniccfg -d6
racadm setniccfg -s <IPv4Address> <netmask> <IPv4
gateway>
Table 2-13. serveraction Subcommand Options
String Definition
<action> Specifies the action. The options for the <action> string are:
• powerdown — Powers down the managed system.
•
powerup — Powers up the managed system.
•
powercycle — Issues a power-cycle operation on the managed
system. This action is similar to pressing the power button on the
system’s front panel to power down and then power up the system.
•
powerstatus — Displays the current power status of the server (ON
or OFF)
•
hardreset — Performs a reset (reboot) operation on the managed
system.
Subcommand Definition
setniccfg Sets the IP configuration for iDRAC6.