Users Guide

368 RACADM Subcommand Overview
Description
The racresetcfg command removes all database property entries that have
been configured by the user. The database has default properties for all
entries that are used to restore the controller back to its original default
settings. After resetting the database properties, the iDRAC6 resets
automatically.
NOTE: This command deletes your current iDRAC6 configuration and resets the
iDRAC6 and serial configuration to the original default settings. After reset, the
default name and password is root and calvin, respectively, and the IP address is
192.168.0.120. If you issue racresetcfg from a network client (for example, a
supported Web browser, Telnet/ssh, or remote RACADM), you must use the default
IP address.
NOTE: Certain iDRAC6 firmware processes need to be stopped and restarted for
reset to defaults to complete. iDRAC6 will become unresponsive for about 30
seconds while this operation completes.
serveraction
NOTE: To use this command, you must have Execute Server Control Commands
permission.
Table A-27 describes the serveraction subcommand.
Synopsis
racadm serveraction < action >
Description
The serveraction subcommand enables users to perform power management
operations on the host system. Table A-28 describes the serveraction power
control options.
Table A-27. serveraction
Subcommand Definition
serveraction Executes a managed system reset or power-on/off/cycle.