Users Guide

RACADM Subcommand Overview 361
Synopsis
racadm netstat
Supported Interfaces
• Remote RACADM
• Telnet/ssh/serial RACADM
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure iDRAC permission.
Table A-19 describes the ping subcommand.
Synopsis
racadm ping < ipaddress >
Supported Interfaces
• Remote RACADM
• Telnet/ssh/serial RACADM
setniccfg
NOTE: To use the setniccfg command, you must have Configure iDRAC permission.
Table A-18. netstat
Subcommand Definition
netstat Displays the routing table and the current connections.
Table A-19. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable from the iDRAC6
with the current routing-table contents. A destination IP address is
required. An ICMP echo packet is sent to the destination IP address
based on the current routing-table contents.