Users Guide

344 RACADM Subcommand Overview
NOTE: The configuration file retrieved using remote racadm and local racadm are
not interoperable. The configuration file retrieved using remote racadm shows the
index property for some of the indexed groups as read-write, for example
cfgSSADRoleGroupIndex. For the "config -f <file name>" command, use the
configuration file retrieved from the same interface. For example, for local racadm
"config -f <file name>", use the file generated from the local racadm command
"getconfig -f <file name>" .
Input
Table A-5 describes the config subcommand options.
NOTE: The -f and -p options are not supported for the serial/Telnet/ssh console.
Table A-5. config Subcommand Options and Descriptions
Option Description
-f The -f
<filename> option causes config to read the contents of the file
specified by <filename> and configure the iDRAC6. The file must
contain data in the format specified in "Parsing Rules."
-p The -p, or password option, directs config to delete the password entries
contained in the config file -f
<filename> after the configuration is
complete.
-g The -g
<groupName>, or group option, must be used with the -o option.
The <groupName> specifies the group containing the object that is to be
set.
-o The -o
<objectName> <Value>, or object option, must be used with the
-g option. This option specifies the object name that is written with the
string <value>.
-i The -i
<index>, or index option, is only valid for indexed groups and can
be used to specify a unique group. The <index> is a decimal integer from
1 through 16. The index is specified here by the index value, not a
"named" value.
-c The -c, or check option, is used with the config subcommand and allows
the user to parse the .cfg file to locate syntax errors. If errors are found, the
line number and a short description of what is incorrect are displayed.
Writes do not occur to the iDRAC6. This option is a check only.