Users Guide

118 Advanced iDRAC6 Configuration
Enabling and Disabling the RACADM Remote
Capability
NOTE: It is recommended that you run these commands on your local system.
The RACADM remote capability is enabled by default. If disabled, type the
following
RACADM command to enable:
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 1
To disable the remote capability, type:
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 0
RACADM Subcommands
Table 5-15 provides a description of each RACADM subcommand that you
can run in RACADM. For a detailed listing of RACADM subcommands,
including syntax and valid entries, see "RACADM Subcommand Overview."
When entering a RACADM subcommand, prefix the command with
racadm, for example:
racadm help
Table 5-15. RACADM Subcommands
Command Description
help Lists iDRAC6 subcommands.
help
<subcommand>
Lists usage statement for the specified subcommand.
arp Displays the contents of the ARP table. ARP table entries may
not be added or deleted.
clearasrscreen Clears the last ASR (crash) screen (last blue screen).
clrraclog Clears the iDRAC6 log. A single entry is made to indicate the
user and time that the log was cleared.
config Configures the iDRAC6.
getconfig Displays the current iDRAC6 configuration properties.
coredump Displays the last iDRAC6 coredump.