Users Guide

Advanced iDRAC6 Configuration 113
coredumpdelete Deletes the coredump stored in the iDRAC6.
fwupdate Executes or displays status on iDRAC6 firmware updates.
getssninfo Displays information about active sessions.
getsysinfo Displays general iDRAC6 and system information.
getractime Displays the iDRAC6 time.
ifconfig Displays the current iDRAC6 IP configuration.
netstat Displays the routing table and the current connections.
ping Verifies that the destination IP address is reachable from the
iDRAC6 with the current routing-table contents.
setniccfg Sets the IP configuration for the controller.
getniccfg Displays the current IP configuration for the controller.
getsvctag Displays service tags.
racdump Dumps iDRAC6 status and state information for debug.
racreset Resets the iDRAC6.
racresetcfg Resets the iDRAC6 to the default configuration.
serveraction Performs power management operations on the managed system.
getraclog Displays the iDRAC6 log.
clrsel Clears the System Event Log entries.
gettracelog Displays the iDRAC6 trace log. If used with -i, the command
displays the number of entries in the iDRAC6 trace log.
sslcsrgen Generates and downloads the SSL CSR.
sslcertupload Uploads a CA certificate or server certificate to the iDRAC6.
sslcertdownload Downloads a CA certificate.
sslcertview Views a CA certificate or server certificate in the iDRAC6.
sslkeyupload Forces the iDRAC6 to send a test e-mail over the iDRAC6 NIC
to check the e-mail configuration.
testtrap Forces the iDRAC6 to send a test SNMP trap over the iDRAC6
NIC to check the trap configuration.
vmdisconnect Forces a virtual media connection to close.
vmkey Resets the virtual flash size to its default size (256 MB).
Table 5-15. RACADM Subcommands (continued)
Command Description