Users Guide

Using the iDRAC Configuration Utility 231
Virtual Media Configuration
Virtual Media
Press <Enter> to select Detached, Attached, or Auto-Attached. When you
select Attached, the virtual media devices are attached to the USB bus,
making them available for use during Console Redirection sessions.
If you select Detached, users cannot access virtual media devices during
Console Redirection sessions.
NOTE: To use a USB Flash Drive with the Virtual Media feature, the USB Flash
Drive Emulation Type must be set to Hard disk in the BIOS Setup Utility. The BIOS
Setup Utility is accessed by pressing <F2> during server start-up. If the USB Flash
Drive Emulation Type is set to Auto, the Flash Drive will appear as a floppy drive to
the system.
DNS Server 1 If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
DNS Server 2 If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
Advanced LAN
Configurations
Auto-Negotiate If NIC Selection is set to Dedicated, select between Enabled
and Disabled.
When Enabled is selected, LAN Speed Setting and LAN
Duplex Setting are configured automatically.
LAN Speed
Setting
If Auto-Negotiate is set to Disabled, select between 10 Mbps
and 100 Mbps.
LAN Duplex
Setting
If Auto-Negotiate is set to Disabled, select between Half
Duplex and Full Duplex.
Table 15-1. LAN Parameters (continued)
Item Description