Users Guide

202 Using the iDRAC6 SM-CLP Command Line Interface
Below is an example of the SM-CLP command line syntax.
<verb> [<options>] [<target>] [<properties>]
During a typical SM-CLP session, you can perform operations using the verbs
listed in Table 12-1.
Using SM-CLP
SSH (or telnet) in to the iDRAC6 with correct credentials.
The SMCLP prompt (/admin1->) is displayed.
SM-CLP Targets
Table 12-2 provides a list of targets provided through the SM-CLP to support
the operations described in Table 12-1 above.
Table 12-1. Supported CLI Verbs for System
Verb Definition
cd Navigates through the MAP using the shell
set Sets a property to a specific value
help Displays help for a specific target
reset Resets the target
show Displays the target properties, verbs, and subtargets
start Turns on a target
stop Shuts down a target
exit Exits from the SM-CLP shell session
version Displays the version attributes of a target
load Moves a binary image to a specified target address from a URL