Users Guide

182 Using GUI Console Redirection
Why do multiple Session
Viewer windows appear
when I establish a console
redirection session from the
local host?
You are configuring a console redirection session from
the local system. This is not supported.
If I am running a console
redirection session and a
local user accesses the
managed server, do I receive
a warning message?
No. If a local user accesses the system, both have
control of the system.
How much bandwidth do I
need to run a console
redirection session?
Dell recommends a 5 MB/sec connection for good
performance. A 1 MB/sec connection is required for
minimal performance.
What are the minimum
system requirements for my
management station to run
console redirection?
The management station requires an Intel
®
Pentium
®
III 500 MHz processor with at least 256 MB of RAM.
Why do I see a No Signal
message within the iDRAC
KVM Video Viewer?
You may see this message because the iDRAC Virtual
KVM plugin is not receiving the remote server desktop
video. Generally, this behavior may occur when the
remote server is powered off. Occasionally, the message
may be displayed due to a remote server desktop video
reception malfunction.
Why do I see an Out of
Range message within the
iDRAC KVM Video Viewer?
You may see this message because a parameter
necessary to capture video is beyond the range for
which the iDRAC can capture the video. Parameters
such as display resolution or refresh rate too high will
cause and out of range condition. Usually the
maximum range of parameters is set by physical
limitations such as video memory size or bandwidth.
Table 9-5. Using Console Redirection: Frequently Asked Questions (continued)
Question Answer