Users Guide

128 Adding and Configuring iDRAC6 Users
Removing an iDRAC6 User
When using RACADM, users must be disabled manually and on an
individual basis. Users cannot be deleted by using a configuration file.
The following example illustrates the command syntax that can be used to
delete a RAC user:
racadm config -g cfgUserAdmin -o cfgUserAdminUserName
-i <index> ""
A null string of double quote characters ("") instructs the iDRAC6 to remove
the user configuration at the specified index and reset the user configuration
to the original factory defaults.
Enabling an iDRAC6 User With Permissions
To enable a user with specific administrative permissions (role-based
authority), first locate an available user index by performing the steps in
"Before You Begin." Next, type the following command lines with the new
user name and password.
NOTE: See Table B-2 for a list of valid bit mask values for specific user privileges.
The default privilege value is 0, which indicates the user has no privileges enabled.
racadm config -g cfgUserAdmin -o
cfgUserAdminPrivilege -i
<index> <user privilege
bitmask value>