Users Guide

Adding and Configuring iDRAC6 Users 125
Using the RACADM Utility to Configure
iDRAC6 Users
NOTE: You must be logged in as user root to execute RACADM commands on a
remote Linux system.
The iDRAC6 Web-based interface is the quickest way to configure an
iDRAC6 user. If you prefer command-line or script configuration or need to
configure multiple iDRAC6 cards, use RACADM, which is installed with the
iDRAC6 agents on the managed system.
To configure multiple iDRAC6 cards with identical configuration settings,
perform one of the following procedures:
• Use the RACADM examples in this section as a guide to create a batch
file of
RACADM commands and then execute the batch file on each
managed system.
• Create the iDRAC6 configuration file as described in "RACADM
Subcommand Overview" and execute the
racadm config subcommand on
each managed system using the same configuration file.
Table 6-7. User Configuration Page Buttons
Button Action
Print Prints the User Configuration values that appear on
the screen.
Refresh Reloads the User Configuration page.
Go Back To Users Page Returns to the Users Page.
Apply Changes Saves any new settings made to the user configuration.