Users Guide

106 Advanced Configuration of the iDRAC6

If the HTTPS port number of the iDRAC6 has been changed to a custom

port other than the default port (443), the following syntax must be used:

racadm -r

<iDRAC6 IP Address>:<port> -u <username> -p

racadm -i -r

RACADM Options

Table 5-14 lists the options for the RACADM command.

Enabling and Disabling the RACADM Remote

Capability

NOTE: It is recommended that you run these commands on your local system.

The RACADM remote capability is enabled by default. If disabled, type the

following

RACADM command to enable:

Table 5-14. racadm Command Options

Option Description

-r <racIpAddr>

-r <racIpAddr>:<port

number>

Specifies the controller’s remote IP address.

Use:<port number> if the iDRAC6 port number is not

the default port (443)

-i Instructs RACADM to interactively query the user for

user name and password.

-u <usrName> Specifies the user name that is used to authenticate

the command transaction. If the -u option is used, the

-p option must be used, and the -i option (interactive)

is not allowed.

-p <password> Specifies the password used to authenticate the

command transaction. If the -p option is used, the -i

option is not allowed.

-S Specifies that RACADM should check for invalid

certificate errors. RACADM stops the execution of the

command with an error message if it detects an invalid

certificate.