Users Guide

96 Configuring iDRAC6 Enterprise Using the Web Interface
4 Click Trap Settings .
The
Trap Settings screen is displayed.
5 Configure your PET destination IP address:
a Select the Enabled check box for the Destination Number you would
like to activate.
b Enter an IP address in the appropriate IPv4 or IPv6 Destination IP
Address
box.
c Click Apply .
NOTE: To successfully send a trap, configure the Community String value.
The Community String value indicates the community string to use in a Simple
Network Management Protocol (SNMP) alert trap sent from iDRAC6. SNMP
alert traps are transmitted by iDRAC6 when a platform event occurs. The
default setting for the Community String is Public.
d
To test the configured alert, click Send .
e To add an additional destination IP address, repeat step a through
step d. You may specify up to four IPv4 and four IPv6 destination
addresses.
Configuring E-Mail Alerts
1 Log in to iDRAC6 Web interface.
2 Ensure that you followed the procedures in "Configuring Platform Event
Filters (PEF)" on page 95.
3 Click System , and then click the Alert Management tab.
The
Platform Events screen is displayed.
4 Click Email Alert Settings .
The
Email Alert Settings screen is displayed.