Users Guide

Configuring iDRAC6 Enterprise 41
Configuring Networking for iDRAC6
1 Click System  iDRAC Settings Network/Security tab.
2 To enable or disable Serial Over LAN:
a Click Serial Over LAN .
The
Serial Over LAN screen is displayed.
b Select the Enable Serial Over LAN check box. You may also change
the
Baud Rate and Channel Privilege Level Limit settings.
c Click Apply .
3 To enable or disable IPMI Over LAN:
a Click Network .
The
Network screen is displayed.
b Click IPMI Settings .
c Select the Enable IPMI Over LAN check box. You may also change
the
Channel Privilege Level Limit and Encryption Key settings.
d Click Apply .
4 To enable or disable DHCP:
a Click Network .
The
Network screen is displayed.
b In the IPv4 Settings section, select the DHCP Enable and Use
DHCP to obtain DNS Server Addresses
check boxes.
c In the IPv6 Settings section, select the Autoconfiguration Enable and
the
Use DHCPv6 to obtain DNS Server Addresses check boxes.
d Click Apply .
NOTE: If you choose not to enable DHCP, you must enter the static
IP address, netmask, and default gateway for the server.