Users Guide

Using the RACADM Command Line Interface 277

getsysinfo Displays information about iDRAC6 and the managed server,

including IP configuration, hardware model, firmware

versions, and operating system information.

gettracelog Displays iDRAC6 trace log. If used with -i, the command

displays the number of entries in iDRAC6 trace log.

help Lists iDRAC6 subcommands.

help

Lists usage statement for the specified subcommand.

ifconfig Displays the contents of the network interface table.

krbkeytabupload Uploads a Kerberos keytab file.

localconredirdisable Performs local Virtual Console disable from the local system.

netstat Displays the routing table and the current connections.

ping Verifies that the destination IP address is reachable from

iDRAC6 with the current routing-table contents. A

destination IP address is required. An ICMP echo packet is

sent to the destination IP address based on the current

routing-table contents.

ping6 Verifies that the destination IPv6 address is reachable from

iDRAC6 with the current routing-table contents. A

destination IPv6 address is required. An ICMP echo packet is

sent to the destination IPv6 address based on the current

routing-table contents.

racdump Displays status and general iDRAC6 information.

racreset Resets iDRAC6.

racresetcfg Resets iDRAC6 to the default configuration.

remoteimage Remote file share

serveraction Performs power management operations on the

managed server.

setniccfg Sets the IP configuration for the controller.

sshpkauth Enables you to upload up to 4 different SSH public keys,

delete existing keys, and view the keys already in iDRAC6.

Table 13-1. RACADM Subcommands

(continued)

Command Description