Users Guide

264 Configuring and Using Virtual Media
Configuring Virtual Media
1 Log in to iDRAC6 Web interface.
2 Click System  Virtual Console/Media  Configuration .
3 In the Virtual Media section, select values for the settings. See Table 12-2
for information on Virtual Media configuration values.
4 Click Apply to save your settings.
An alert dialog is displayed with the following message:
You are
about to change device configuration. All existing
redirection sessions will be closed. Do you want
to continue?
5
Click OK to continue.
An alert dialog is displayed with the following message:
Virtual
Media Configuration successfully set.
Table 12-2. Virtual Media Configuration Values
Attribute Value
Attach Virtual Media Attach — Immediately attaches Virtual Media to the
server.
Detach — Immediately detaches Virtual Media from
the server.
Auto-Attach — Attaches Virtual Media to the server
only when a Virtual Media session is started.
Maximum Sessions Displays the maximum number of Virtual Media
sessions allowed. This value is always 1.
NOTE: Only one virtual media user session is allowed;
however, multiple devices can be attached in a single
session. See "Running Virtual Media" on page 265.
Active Sessions Displays the number of Virtual Media sessions that are
currently active.
Virtual Media Encryption
Enabled
Enables (checked) or disables (not checked)
encryption on Virtual Media connections.