Users Guide

128 Using iDRAC6 Directory Service

You can use Active Directory to log in to iDRAC6 using one of the following

methods:

•Web interface

•Local RACADM

• SSH or Telnet console for SM-CLP CLI

The login syntax is the same for all three methods:

<username@domain>

where username is an ASCII string of 1–256 bytes.

White space and special characters (such as \, /, or @) cannot be used in the

user name or the domain name.

NOTE: You cannot specify NetBIOS domain names, such as Americas, because

these names cannot be resolved.

If you log in from the Web interface and you have configured user domains, the

Web interface log in screen will list all the user domains in the pull-down menu

for you to choose. If you select a user domain from the pull-down menu, you

should only enter the user name. If you select This iDRAC, you can still log in

as an Active Directory user if you use the login syntax described above in "Using

iDRAC6 With Microsoft Active Directory" on page 127.

Execute Diagnostic

Commands

Enables the user to run diagnostic commands

Table 6-1. iDRAC6 User Privileges

(continued)

Privilege Description