Users Guide

92 Configuring iDRAC6 Enterprise Using the Web Interface
Configuring IP Filtering and IP Blocking
NOTE: You must have Configure iDRAC6 privilege to perform the following steps.
1 Click System  iDRAC Settings.
2 Click the Network/Security tab.
The
Network screen is displayed.
3 Click Advanced Settings .
The
Network Security screen is displayed.
Table 5-4. VLAN Settings
Button Description
Enable VLAN ID Yes—Enabled. No—Disabled. If enabled, only matched Virtual
LAN (VLAN) ID traffic is accepted.
NOTE: The VLAN settings can only be configured through CMC
Web Interface. iDRAC6 only displays the current enablement
status; you can not modify the settings on this screen.
VLAN ID VLAN ID field of 802.1g fields. Displays a value from 1 to 4094
except 4001 to 4020.
Priority Priority field of 802.1g fields. This is used to identify the
priority of the VLAN ID and displays a value from 0 to 7 for the
VLAN Priority.
Table 5-5. Network Configuration Buttons
Button Description
Advanced Settings Displays the Network Security screen, allowing you to enter the
IP Range and IP Blocking attributes.
Apply Saves any new settings made to the network configuration
screen.
NOTE: Changes to the NIC IP address settings close all user
sessions and require users to reconnect to iDRAC6 Web interface
using the updated IP address settings. All other changes require
the NIC to be reset, which may cause a brief loss in connectivity.