Users Guide

148 Using iDRAC6 Directory Service
If Standard Schema is selected, the domain controllers are where the user
accounts and the role groups are located.
NOTE: iDRAC6 does not failover to the specified domain controllers when
DNS lookup fails, or none of the servers returned by the DNS lookup works.
12 Select the Specify Domain Controller Addresses option to allow iDRAC6
to use the Active Directory Domain Controller server addresses that are
specified. DNS lookup is not performed. Specify the IP address or the
FQDN of the domain controllers. When the
Specify Domain Controller
Addresses
option is selected, at least one of the three addresses is required
to be configured. iDRAC6 attempts to connect to each of the configured
addresses one by one until it makes a successful connection. If
Extended
Schema
is selected, these are the addresses of the domain controllers
where iDRAC6 device object and the Association objects are located.
NOTE: The FQDN or IP address that you specify in this field should match the
Subject or Subject Alternative Name field of your domain controller
certificate if you have certificate validation enabled.
13 Click Next .
The
Step 3 of 4 Active Directory Configuration and Management screen
is displayed.
14 Under Schema Selection , select the Extended Schema Selection check
box.
15 Click Next .
The
Step 4 of 4 Active Directory screen is displayed.
16 Under Extended Schema Settings , enter iDRAC6 Name and iDRAC6
Domain Name
to configure iDRAC6 device object and its location in
Active Directory.
17 Click Finish to save your changes, and then Done .
The main
Active Directory Configuration and Management summary
page is displayed. Next, test the Active Directory settings you just
configured.
18 Scroll to the bottom of the screen and click Test Settings .
The
Test Active Directory Settings screen is displayed.