Release Notes

Issue 27
Description
The WS-MAN CQL filtering implementation in this release is experimental, and it is recommended not to use this currently.
Issue 28
Description
The embedded NIC MAC addresses displayed under System > Properties >System Details are the server assigned MAC
addresses. If the MAC addresses are remotely managed or chassis assigned, the active MAC addresses can be found under
System > Properties > WWN/MAC.
Issue 29
Description
When launching the iDRAC GUI and iDRAC virtual console from the CMC within a few seconds of each other, the iDRAC GUI
may have a session timeout. This can also happen any time the virtual console is launched from the CMC after the iDRAC
GUI has been launched from the CMC. This is expected behavior because of browser session management.
Issue 30
Description
Remotely managed MAC addresses require appropriate hardware and firmware. To fully enable remote management of MAC
addresses, CMC 3.20 (or later) must be installed.
Issue 31
Description
In iDRAC6 3.2 User Guide, in Chapter 19, the note about special characters in the Viewing and Adding Work Notes Section
has been updated in the product. Special characters are no longer converted to '%' character as mentioned in the note. You
can now use special characters except for ‘<’ and ‘&’. If you use these characters, you may not be able to save the work
note.
Issue 32
Description
In the RACADM Command Line Reference Guide, the cfgServerBootOnce default value is actually 1 and not 0.
Issue 33
Description
In the iDRAC GUI, System > Logs > Work Notes page, the note about the length of a new work note indicates that the
maximum number of characters supported is 50.