Users Guide

244 Configuring the vFlash SD Card and Managing vFlash Partitions
Enabling or Disabling the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
command:
• To enable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
1
• To disable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
0
NOTE: The RACADM command functions only if a vFlash or standard SD card is
present. If a card is not present, the following message is displayed: ERROR: SD
Card not present.
Initializing the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
command:
racadm vflashsd initialize
All existing partitions are deleted and the card is reset.
Getting the Last Status on the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
command to get the status of the last command sent to the vFlash or
standard SD card:
racadm vFlashsd status