Release Notes

file:///T|/htdocs/SOFTWARE/smdrac3/idrac/idrac32Modular/en/readme/readme.txt[10/26/2012 1:10:59 PM]
* To execute iDRAC DUPs in XenServer(TM) 5.6, you must install
the procmail package. You can install the procmail RPM in CentOS
5.4 i386, which can be downloaded from any public site that hosts
CentOS packages. However, it is recommend not to install *any*
RPMs manually on XenServer, instead it is recommended that you
download and install the OpenManage Supplemental Pack from
support.dell.com. It contains the procmail package and is the
supported method for installing third party packages and applications
in XenServer.
* Using the iDRAC web console to shutdown the XenServer operating
system by selecting "Graceful Shutdown" does not shut down the
server. As best practice, it is recommended that you use the
shutdown menu option in the XenServer console or in the XenCenter
management GUI.
* TFTP firmware update from local RACADM will not work after a
racresetcfg or if IPv6 addresses are used. Use the firmware
RACADM for TFTP firmware update.
* When using the virtual console on RHEL with Firefox, if the
network connection to the iDRAC is lost a blank message box
may pop up. If the network connection is shortly restored
the message box may eventually display the “Virtual Console
is restarted” message and will then close. Normally the
message will immediately display in the message box but on
rare occasions it may not display. The display of the message
is controlled by the JRE and if the blank message box is
seen this is not an iDRAC firmware issue.
* When connecting to the iDRAC GUI using browsers supporting
localized languages, some popups may have generic messages that
are not localized in the title such as: "The page at
https://10.35.155.207 says:". This is a browser limitation
and cannot be changed in the iDRAC.
* When using the Virtual Console that uses the Java plug-in with attached
Virtual Media, occasionally when disconnecting the Virtual Media the
console also closes unexpectedly. When this happens, restart
the Virtual Console to regain access.
* During the SLES 11 installation through the "Dell Systems Management
Tools and Documentation" DVD, if the DVD is connected through Virtual
Media, the image installation may not proceed after the system
configuration step. It shows a warning dialog message similar to
the following:
"Empty destination in URL: hd:///install/?device=/dev/sdc1".
To continue the installation, delete the question mark ‘?’, refresh
the URL and the installation will proceed. This issue is not seen when
using the managed system's local CD/DVD or using the operating system DVD
directly instead of the "Dell Systems Management Tools and
Documentation" DVD.
* When using the WSMan DCIM_RAIDService GetAvailableDisks method to retrieve