Users Guide

Configuring iDRAC6 Enterprise Using the Web Interface 87
The Network Security screen appears.
4 Configure IP filtering and blocking settings as needed. See Table 5-6 for
descriptions of the IP filtering and blocking settings.
5 Click Apply .
6 Click the appropriate button to continue. See Table 5-7.
Table 5-6. IP Filtering and Blocking Settings
Settings Description
IP Range Enabled Enables the IP Range checking feature, which defines a range of
IP addresses that can access iDRAC6. The default is Disabled.
IP Range Address Determines the acceptable IP subnet address. The default is
192.168.1.0.
IP Range Subnet
Mask
Defines the significant bit positions in the IP address.
The subnet mask should be in the form of a netmask, where the
more significant bits are all 1's with a single transition to all
zeros in the lower-order bits. The default is 255.255.255.0.
IP Blocking
Enabled
Enables the IP address blocking feature, which limits the
number of failed login attempts from a specific IP address for a
preselected time span. The default is Disabled.
IP Blocking Fail
Count
Sets the number of login failures attempted from an IP address
before the login attempts are rejected from that address.
The default is 10.
IP Blocking Fail
Window
Determines the time span in seconds within which IP Block
Fail Count failures must occur to trigger the IP Block Penalty
Time. The default is 3600.
IP Blocking Penalty
Time
The time span in seconds that login attempts from an
IP address with excessive failures are rejected. The default
is 3600.
Table 5-7. Network Security Buttons
Button Description
Print Prints the Network Security values that appear on the screen.
Refresh Reloads the Network Security screen.