Users Guide

Using the RACADM Command Line Interface 275
a Update the IPMI SOL minimum privilege level using the following
command:
racadm config -g cfgIpmiSol -o
cfgIpmiSolMinPrivilege
<level>
where <level> is one of the following:
•
2 ( User )
•
3 ( Operator )
•
4 ( Administrator )
For example, to configure the IPMI privileges to 2 (User), enter the
following command:
racadm config -g cfgIpmiSol -o
cfgIpmiSolMinPrivilege 2
NOTE: To redirect the serial console over LAN, ensure that the SOL baud rate
is identical to your managed server’s baud rate.
b Update the IPMI SOL baud rate using the following command:
racadm config -g cfgIpmiSol -o
cfgIpmiSolBaudRate
<baud-rate>
where <baud-rate> is 19200, 57600, or 115200 bps.
For example:
racadm config -g cfgIpmiSol -o
cfgIpmiSolBaudRate 57600
c Enable SOL by typing the following command at the command prompt.
NOTE: SOL can be enabled or disabled for each individual user.
racadm config -g cfgUserAdmin -o
cfgUserAdminSolEnable 1 -i <id>
where <id> is the user’s unique ID.