Users Guide

Configuring iDRAC6 Enterprise 49
Configuring Networking for iDRAC6
1 Click System → Remote Access → iDRAC6 .
2 Click the Network/Security tab:
To enable or disable Serial Over LAN:
a Click Serial Over LAN .
The
Serial Over LAN screen appears.
b Select the Enable Serial Over LAN check box. You may also change
the
Baud Rate and Channel Privilege Level Limit settings.
c Click Apply .
To enable or disable IPMI Over LAN:
a Click Network .
The
Network screen appears.
b Click IPMI Settings .
c Select the Enable IPMI Over LAN check box. You may also change
the
Channel Privilege Level Limit and Encryption Key settings.
d Click Apply .
To enable or disable DHCP:
a Click Network .
The
Network screen appears.
b Select the DHCP Enable check box in the IPv4 Settings section and
the
Autoconfiguration Enable checkbox in the IPv6 Settings section
to enable DHCP. To use DHCP to obtain DNS server addresses, select
the
Use DHCP to obtain DNS Server Addresses check box.
c Click Apply .
NOTE: If you choose not to enable DHCP, you must enter the static
IP address, netmask, and default gateway for the server.