Users Guide

RACADM Subcommand Overview 377
Synopsis
racadm ping < ipaddress >
Supported Interfaces
• Remote RACADM
• telnet/ssh RACADM
ping6
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure iDRAC6 permission.
Table A-48 describes the ping6 subcommand.
Synopsis
racadm ping6 < ipv6address >
Supported Interfaces
• Remote RACADM
• telnet/ssh RACADM
racdump
NOTE: To use this command, you must have Debug permission.
Table A-49 describes the racdump subcommand.
Table A-48. ping6
Subcommand Definition
ping6 Verifies that the destination IPv6 address is reachable from iDRAC6
with the current routing-table contents. A destination IPv6 address is
required. An ICMP echo packet is sent to the destination IPv6 address
based on the current routing-table contents.
Table A-49. racdump
Subcommand Definition