Users Guide

Configuring iDRAC6 Enterprise Using the Web Interface 85
Configuring IP Filtering and IP Blocking
NOTE: You must have Configure iDRAC permission to perform the following steps.
1 Click System → Remote Access → iDRAC.
2 Click the Network/Security tab.
The
Network Configuration screen appears.
3 Click Advanced Settings .
The
Network Security screen appears.
4 Configure IP filtering and blocking settings as needed. See Table 5-5 for
descriptions of the IP filtering and blocking settings.
5 Click Apply .
6 Click the appropriate button to continue. See Table 5-6.
Table 5-4. Network Configuration Buttons
Button Description
Advanced Settings Opens the Network Security screen, allowing the user to enter
IP Range, and IP Blocking attributes.
Print Prints the Network Configuration values that appear on the
screen.
Refresh Reloads the Network Configuration screen.
Apply Saves any new settings made to the network configuration
screen.
NOTE: Changes to the NIC IP address settings will close all user
sessions and require users to reconnect to the iDRAC6 Web
interface using the updated IP address settings. All other changes
will require the NIC to be reset, which may cause a brief loss in
connectivity.