Users Guide

RACADM Subcommand Overview 327
Description
Sends a test e-mail from iDRAC6 to a specified destination.
Prior to executing the testemail command, ensure that the specified index in
the RACADM cfgEmailAlert group is enabled and configured properly.
Table A-33 provides an example of commands for the cfgEmailAlert group.
Options
Table A-34 describes the testemail subcommand options.
Output
None.
Table A-33. testemail Configuration
Action Command
Enable the alert racadm config -g cfgEmailAlert -o
cfgEmailAlertEnable
-i 1 1
Set the destination
e-mail address
racadm config -g cfgEmailAlert -o
cfgEmailAlertAddress -i 1
[e-mail]
Set the custom message
that is sent to the
destination e-mail
address
racadm config -g cfgEmailAlert -o
cfgEmailAlertCustomMsg -i 1 "This is a
test!"
Ensure the SNMP IP
address is configured
properly
racadm config -g cfgRemoteHosts -o
cfgRhostsSmtpServerIpAddr -i
192.168.0.152
View the current e-mail
alert settings
racadm getconfig -g cfgEmailAlert -i
<index>
where <index> is a number from 1 to 4
Table A-34. testemail Subcommand Option
Option Description
-i Specifies the index of the e-mail alert to
test.