Users Guide

Recovering and Troubleshooting the Managed Server 297
How can I find
the IP address of
iDRAC6?
From the CMC Web interface:
1 Click Chassis → Servers , then click the Setup tab.
2 Click Deploy .
3 Read the IP address for your server from the table that is
displayed.
From the iKVM:
• Reboot the server and enter the iDRAC6 Configuration Utility
by pressing <Ctrl><E>.
OR
• Watch for the IP address to display during BIOS POST.
OR
• Select the "Dell CMC" console in the OSCAR to log in to the
CMC through a local serial connection.
CMC RACADM commands can be issued from this connection.
Refer to the CM
C Firmware User Guide for a complete list of the
CMC RACADM subcommands.
You can also use the local RACADM getsysinfo command to view
the iDRAC6 IP address.
For example:
$ racadm getniccfg -m server-1
DHCP Enabled = 1
IP Address = 192.168.0.1
Subnet Mask = 255.255.255.0
Gateway = 192.168.0.1
From local RACADM:
1 Enter the following command at a command prompt:
racadm getsysinfo
From the LCD:
1 On the Main Menu, highlight Server and press the check button.
2 Select the server whose IP address you seek and press the
check button.
Table 17-17. Frequently Asked Questions/Troubleshooting (continued)
Question Answer