Users Guide

Using the Local RACADM Command Line Interface 241
Configuring Multiple iDRACs
Using a configuration file, you can configure other iDRACs with identical
properties. Follow these steps to configure multiple iDRACs:
1
Create the configuration file from the iDRAC6 settings you want to
replicate to the others. At a command prompt on the managed server,
enter the following command:
racadm getconfig -f < filename >
where < filename > is the name of a file to save the iDRAC6 properties,
such a
myconfig.cfg .
See "Creating an iDRAC6 Configuration File" for more information.
NOTE: Some configuration files contain unique iDRAC6 information (such as the
static IP address) that must be modified before you export the file to other iDRACs.
2 Edit the configuration file you created in the previous step and remove or
comment-out any settings you
do not want to replicate.
3 Copy the edited configuration file to a network drive where it is accessible
to each managed server whose iDRAC6 you want to configure.
4 For each iDRAC6 you want to configure:
a Log in to the managed server and start a command prompt.
b If you want to reconfigure iDRAC6 from the default settings, enter
the following command:
racadm racreset
c Load the configuration file into iDRAC6 with the following
command:
racadm config -f < filename >
where < filename > is the name of the configuration file you created.
Include the full path if the file is not in the working directory.
d Reset the iDRAC6 that was configured by entering the following
command:
racadm reset