Users Guide

Using the Local RACADM Command Line Interface 227
Configuring IPMI Over LAN
1 Configure IPMI over LAN by entering the following command:
racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
NOTE: This setting determines the IPMI commands that can be executed from the
IPMI over LAN interface. For more information, see the IPMI 2.0 specifications.
a
Update the IPMI channel privileges by entering the following
command:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit
<level>
where <level> is one of the following:
•
2 ( User )
•
3 ( Operator )
•
4 ( Administrator )
For example, to set the IPMI LAN channel privilege to 2 (User), enter
the following command:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit 2
b Set the IPMI LAN channel encryption key, if required, using a
command such as the following:
NOTE: The iDRAC6 IPMI supports the RMCP+ protocol. See the IPMI 2.0
specifications for more information.
racadm config -g cfgIpmiLan -o
cfgIpmiEncryptionKey
<key>
where < key > is a 20-character encryption key in a valid
hexadecimal format.