Users Guide

222 Using the Local RACADM Command Line Interface

For example, to display a list of all cfgLanNetworking group object settings,

enter the following command:

racadm getconfig -g cfgLanNetworking

Managing iDRAC6 Users with RACADM

NOTE: Use caution when using the racresetcfg command, as all configuration

parameters are reset to the original defaults. Any previous changes are lost.

NOTE: If you are configuring a new iDRAC6 or if you ran the racadm racresetcfg

command, the only current user is root with the password calvin.

NOTE: Users can be enabled and disabled over time. As a result, a user may have a

different index number on each iDRAC6.

NOTE: Users and groups created for Active Directory environments must conform

to the Active Directory naming convention.

You can configure up to 15 users in the iDRAC6 property database.

(A sixteenth user is reserved for the IPMI LAN user.) Before you manually

enable an iDRAC6 user, verify if any current users exist.

To verify if a user exists, enter the following command at the command prompt:

racadm getconfig -u <

username

enter the following command once for each index from 1 to 16:

racadm getconfig -g cfgUserAdmin -i <

index

NOTE: You can also enter racadm getconfig -f <

filename

> and view

the generated <filename> file, which includes all users, as well as all other iDRAC6

configuration parameters.

Several parameters and object IDs are displayed with their current values.

Two objects of interest are:

# cfgUserAdminIndex=

cfgUserAdminUserName=