Users Guide

110 Configuring iDRAC6 Enterprise Using the Web Interface
6 In the Firmware Update - Validation (page 2 of 4) window, you will see
the results of the validation performed on the image file you uploaded.
• If the image file uploaded successfully and passed all verification
checks, a message will appear indicating that the firmware image has
been verified.
OR
• If the image did not upload successfully, or it did not pass the
verification checks, the firmware update will return to the
Firmware
Update - Upload (page 1 of 4)
window. You can attempt to upgrade
iDRAC6 again or click
Cancel to reset iDRAC6 to normal operating
mode.
NOTE: If you deselect the Preserve Configuration checkbox, iDRAC6 will be reset
to its default settings. In the default settings, the LAN is disabled. You will not be
able to log in to the iDRAC6 Web interface. You will have to reconfigure the LAN
settings using the CMC Web interface or iKVM using the iDRAC6 Configuration
Utility during BIOS POST.
7 By default the Preserve Configuration checkbox is checked, to preserve
the current settings on iDRAC6 after an upgrade. If you do not want the
settings to be preserved, deselect the
Preserve Configuration checkbox.
8 Click Begin Update to start the upgrade process. Do not interrupt the
upgrade process.
9 In the Firmware Update - Updating (page 3 of 4) window, you will see the
status of the upgrade. The progress of the firmware upgrade operation,
measured in percentages, will appear in the
Progress column.
10 Once the firmware update is complete, the Firmware Update - Update
Results (page 4 of 4)
window will appear and iDRAC6 will reset
automatically. You must close the current browser window and reconnect
to iDRAC6 using a new browser window.