Release Notes

file:///T|/htdocs/SOFTWARE/smdrac3/idrac/idrac20modular/en/readme/readme.txt[10/26/2012 1:22:48 PM]
To use iVMCLI from within a system running Windows Vista -
The user has to start up the 'cmd' with 'Run as Administrator'.
(iVMCLI requires the user has 'administrator' privileges when it is used.)
NOTE -
The user can log in as a non-admin user, but when using iVMCLI, the user
has to start 'cmd' with 'Run as Administrator' thereby giving them
admin privileges to enable using iVMCLI.
######################################################################
KNOWN ISSUES FOR DOCUMENTATION
######################################################################
This section provides additional information about known issues with
the iDRAC Firmware version 2.00 User's Guide.
* None - Initial release
######################################################################
Information in this document is subject to change without notice.
(C) 2009 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission
of Dell Inc. is strictly forbidden.
Trademarks used in this text: "Dell", "OpenManage", and
"PowerEdge" are trademarks of Dell Inc.; "Microsoft", "Windows",
"Windows Server", "Windows Vista", and "Active Directory" are
trademarks or registered trademarks of Microsoft Corporation;
"Red Hat" and "Linux" are registered trademarks of Red Hat, Inc.;
VMware is a registered trademark of VMware, Inc. in the United States
and/or other jurisdictions.
Other trademarks and trade names may be used in this document to refer
to either the entities claiming the marks and names or their products.
Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than its own.
March 2009