Users Guide
Table Of Contents
- Dell EMC iDRAC Service Module 4.0.1 User’s Guide
- Contents
- Introduction
- Preinstallation setup
- Installing iDRAC Service Module
- Initial installation of iDRAC Service Module through iDRAC Enterprise or Datacenter or iDRAC Express on Microsoft Windows and Linux
- Installing iDRAC Service Module on Microsoft Windows operating systems
- Silent installation of iDRAC Service Module on Microsoft Windows
- Modifying iDRAC Service Module components on Microsoft Windows operating systems
- Repairing iDRAC Service Module running on Microsoft Windows operating systems
- Uninstalling iDRAC Service Module running on Microsoft Windows operating systems
- Installing the iDRAC Service Module on VMware ESXi
- Installing iDRAC Service Module on supported Linux operating systems
- Installing iDRAC Service Module when System Configuration Lock Down Mode is enabled in iDRAC
- Configuring iDRAC Servcie Module
- Security configurations and compatibility
- iSM monitoring features
- S.M.A.R.T monitoring
- Operating system information
- Lifecycle Controller log replication into operating system
- Automatic system recovery
- Windows Management Instrumentation Providers
- Prepare to remove a NVMe PCIe SSD device
- Remote iDRAC hard reset
- iDRAC access via Host OS
- Accessing iDRAC via GUI, WS-Man, Redfish, and Remote RACADM
- In-Band support for iDRAC SNMP alerts
- Enable WS-Man remotely
- Autoupdating iSM
- FullPowerCycle
- SupportAssist on the box
- Configuring the In-Band SNMP Get feature—Linux
- Configuring the In-Band SNMP Get feature—Windows
- iDRAC GUI Launcher
- Single sign-on to iDRAC UI from host operating system administrators desktop
- IPv6 communication between iSM and iDRAC over OS-BMC Passthru
- Frequently asked questions
- Linux and Ubuntu installer packages
- Resources and support
- Contacting Dell EMC
Frequently asked questions
This section lists some frequently asked questions about the iDRAC Service Module (iSM).
iSM communication with iDRAC switches from IPv4
protocol to IPv6 protocol
iSM communication with iDRAC switches from IPv4 to IPv6 protocol, when you run ifconfig iDRAC down, when iSM is
communicating with iDRAC through IPv4.
Table 16. The change in protocol when you run the command
Feature/Protocol IPv4 on Linux IPv4 on Windows IPv6 on Linux IPv6 on Windows
OS information Yes Yes Yes Yes
WMI N/A Yes N/A Yes
SupportAssist Yes Yes Yes Yes
Invoke-iDRACLauncher Yes Yes Yes Yes
Invoke-
iDRACHardReset
Yes Yes Yes Yes
Invoke-
VirtualPowerCycle
Yes Yes Yes Yes
Host SNMP Get Yes Yes No No
In-Band SNMP Traps Yes Yes Yes Yes
iDRAC SSO Launcher Yes Yes Yes(ULA) Yes(ULA)
Auto System Recovery Yes Yes Yes Yes
iDRAC In-Band Access Yes Yes No No
iSM Auto Update Yes Yes No No
NVMe Prepare to
Remove
Yes Yes Yes Yes
Server Storage
Correlation
Yes Yes Yes Yes
S.M.A.R.T logs on AHCI Yes Yes Yes Yes
Multiple iDRAC SSO sessions are active over both
IPv4 and ULA address
When user changes the IPv4 or ULA address in the iSM, multiple sessions are created. The old IP address is eventually deleted.
Workaround: Manually delete the old IP address.
7
Frequently asked questions 41