Users Guide

iDRAC Service Module monitoring features
The services provided are:
OS information
Lifecycle Controller Log replication into operating system
Automatic system recovery
Windows Management Instrumentation providers inclusive of storage data
Prepare to remove NVMe SSD device
Remote iDRAC hard reset
iDRAC access via Host OS
In-band support for iDRAC SNMP alerts
Enable WSMan remotely
Auto-updation of iDRAC Service Module
FullPowerCycle
Support Assist on the Box
NOTE: FullPowerCycle and Support Assist on the Box are supported only on the yx4x and yx5x Servers.
Topics:
S.M.A.R.T Monitoring
Operating system information
Lifecycle Controller log replication into operating system
Automatic System Recovery
Windows Management Instrumentation Providers
Prepare to remove NVMe PCIe SSD device
Remote iDRAC hard reset
iDRAC access via Host OS
Accessing iDRAC Via GUI, WSMan, Redfish, Remote RACADM
In-band support for iDRAC SNMP alerts
Enable WSMan Remotely
Auto-updating iDRAC Service Module
FullPowerCycle
SupportAssist on the Box
Enabling the In-band SNMP Get feature—Linux
Enabling the In-band SNMP Get feature—Windows
iDRAC GUI Launcher
Single sign-on (SSO) to iDRAC GUI from Host OS administrators desktop
IPv6 communication between iSM and iDRAC over OS-BMC Passthru
Enhanced security between iSM and iDRAC communication using TLS protocol
S.M.A.R.T Monitoring
Starting iSM 3.5, S.M.A.R.T monitoring feature supports hard disk drives enabled with SATA in AHCI mode. It has built-in capability to
monitor S.M.A.R.T alerts through iDRAC supported auditing methods for hard drives under SATA Chipset controller. Previously the alerts
were monitored by any open-source utility to monitor the hard drives set in RAID Mode.
This feature is controlled by an attribute registry iDRAC.Embedded.1#ServiceModule.1#ChipsetSATA with the following values:
Attribute Values
Description
Enabled The chipset SATA controllers are monitored for S.M.A.R.T events
in real time.
5
26 iDRAC Service Module monitoring features