Users Guide

Installing iDRAC Service Module

The iDRAC Service Module can be installed in any of the following operating systems:

• Installing the iDRAC Service Module On Microsoft Windows Operating Systems

• Installing iDRAC Service Module on supported Linux operating system

• Installing the iDRAC Service Module on VMware ESXi

• Installing the iDRAC Service Module on Citrix XenServer

Topics:

• Initial installation of iDRAC Service Module through iDRAC for Windows

• Initial installation of iSM through iDRAC Express

• Initial installation of iDRAC Service Module via iDRAC for Linux

• Installing the iDRAC Service Module on Microsoft Windows operating systems

• Installing iDRAC Service Module on supported Linux operating system

• Installing the iDRAC Service Module on VMware ESXi

• Installing the iDRAC Service Module on Citrix XenServer

• Installing iDRAC Service Module when the System Conguration Lock Down Mode is enabled

Initial installation of iDRAC Service Module through

iDRAC for Windows

You can install iSM from the iDRAC interface. Install iSM by a single-click installation using the iDRAC installer packager with the host OS.

By using this installer package, you must not navigate to the Dell support or OM DVD to install iSM. This feature ensures that the

compatible version of iSM is installed for the supported iDRAC rmware.

For initial installation of iSM through iDRAC:

1 Navigate to the iDRAC Service Module Setup page. Click the Install Service Module button.

Service Module Installer dialog box is displayed.

2 Select the appropriate script for your system, and then click Launch Virtual Console.

3 In the Security Warning dialog box, click Continue.

You can view the verifying application status in the dialog box.

4 In the Security Warning dialog box, accept the terms of license agreement, and then click Run.

5 Log in to the remote/local system (Host OS) by using your credentials.

You can nd the installer le in the local system.

NOTE

: The installer is available in the Host OS for 30 minutes. If you do not start the installation within 30 minutes, you

must restart the service module installation.

6 Double-click the volume (SMINST), and run ISM_Win.bat script.

iDRAC Service Module installer wizard is displayed.

7 Proceed with the typical installation steps, and complete the installation.

NOTE

: After the installation is complete, the installer le is deleted from the local/Host

OS.

18 Installing iDRAC Service Module